bulk flow
英 [bʌlk fləʊ]
美 [bʌlk floʊ]
网络 集流; 总体流动; 整体流; 主体流动; 整体流动
双语例句
- But you do not have to have fill stent expansion or full stent apposition to get rid of the bulk of the flow limitation.
但是解决大部分的血流受限并不需要充分的支架扩张或良好的支架安置。 - Sometimes lower die temperatures can create a cool layer of resin on the inner surface of the die that creeps slowly to the die exit and then separates from the bulk flow, causing buildup.
有时，较低的口模温度会在口模内表面上生成一个冷却的树脂层，这个树脂层慢慢地移出到口模出口，然后与本体料流分离，从而引起积料。 - The model with plant cell as a basic unit considered the mass diffusion and bulk flow of each constituent with the tissue during the osmotic dehydration.
模型以植物细胞为传输过程的基本单元，考虑了各组分在细胞内、细胞外、通过细胞膜及胞间连丝的质量扩散，和由于体积收缩而导致的集流传输。 - It is found that the convection heat transfer plays an important part in the bulk above the return flow section and the heat conduction only rises in the bottom region.
研究表明，回流口截面以上区域传热以对流方式为主，底部区域则主要是逐层导热。 - When Reynolds number is increased to 2.4 × 104, the flow structure remained single vortex and it is observed that the bulk flow puts the vortex further into the cavity to decrease its influence.
雷诺数增大到2.4×104，流动依然为单涡结构。局部流态和速度矢量大小显示主流区流体进一步把涡朝间距内挤压，边壁涡影响区域进一步减小。 - Determination of Salicylic Acid in Bulk Pharmaceuticals of Acetyl-Salicylic Acid by Flow Injection Spectrophotometry
原料药乙酰水杨酸中水杨酸的流动注射光度分析法 - Based on wide investigations into the dome-shape arch of the material in various linear hoppers and the ways to eliminate the doming, this article analyses the mechanical properties of bulk material flow and points out that the resistance concentration is the basic factor causing the doming.
本文在广泛调查研究现有各种直线型漏斗的结拱情况和破拱措施的基础上，分析了散料流动的力学特性，指出阻力集中是形成结拱敏感区段的基本原因。 - Protein import from the ER occurs via receptor-mediated protein transport or bulk flow.
蛋白质通过质流和受体介导的途径运输到小泡中。 - Design of automatic control system of bulk cement vertical flow tank
散装水泥立式流动罐自动控制系统的设计 - Under different fill ratios and heat transfer rate, the flow pattern in PHP is transferred form bulk flow to semi-annual flow and annual flow, and the performance of heat transfer is improved.
在不同的充液率和传热量条件下，管内的流动形式会由塞状流逐渐过渡到半环状流和环状流，从而提高了热管的传热能力。 - Proposals for technical renovation of the raise were suggested based on a comprehensive analysis of the field situation and according to the bulk flow rule and ore draw theory.
在综合分析了现场情况，根据散体流动规律及放矿学理论，提出了溜井改造技术方案。 - A certain amount of aggregating agent can remarkably improve the bulk density and flow rate of magnetic powder and the properties of bonded magnets. The appropriate content of the aggregating agent is 0.30wt%.
一定量的专用造粒剂可显著提高磁粉的松装密度和流动性及粘结磁体的性能，最佳含量为030%（质量）。 - Studies on Bulk Solid Flow in Conical Hopper and Pneumatic Transport in Bend
散料的流动性及其在弯管中气力输送的研究 - Basis on the mathematical model of dynamic measurement of bulk material flow which had been derived by authors, a dynamic measurement method of bulk material flow was proposed. A new dynamic measurement system of bulk material flow was developed.
基于笔者建立的散状物料流动态计量数学模型，提出了散状物料流动态计量方法，研制了一种新的散状物料流动态计量系统。 - It's mostly used in bulk or fixed flow cargo transportation.
它多被应用在大宗散货或有固定流向的货物运输上。 - A study on Cross-Correlation Measurement System of Bulk Material Flow inside the Pipeline
管道内离散物料流量相关计量装置的研究 - The experimental results indicate that bulk flow, transition flow and annular flow are the major flow patterns in PHP. Heat Transter Characteristics of the Non-Boiling Annular Two-Phase Flow in a Small Vertical Tube
实验结果表明：在不同的运行条件下，管内会出现塞状流、塞状流和环状流并存的混合流以及环状流等不同的流型。细小竖管内非沸腾气液两相环状流换热特性分析 - The Research on Dynamic Measurement System of Bulk Material Flow
散状物料流动态计量系统的研究 - This paper introduces the principle of crosscorrelation measurement of non-homogeneous bulk material flow in pipeline and the capacitance sensor applying to sampling the random flow noise and concentration signal. A capacitance/ voltage converter was developed.
本文介绍了互相关法测量管道输送非均匀离散物料的原理和电容传感器用于采集随机流动噪声和浓度信号的理论，研制了相应的电容&电压转换器。 - Based on Hirs bulk flow theory, a turbulence model aiming at hydrodynamic face seal ( or thrust bearing) in the polar coordinates system was presented.
基于Hirs湍流润滑理论，针对端面动压密封（或推力轴承润滑）推导了极坐标系下的湍流计算模型。 - In the wide range of inlet subcooling ( 0 K system flow condition, namely, ( 1) stable two-phase flow, ( 2) bulk and subcooled boiling unstable flow, ( 3) subcooled boiling and single phase stable flow.
在进口过冷度相当宽范围内（OK<ΔT<28K），对系统流条件，存在3个区域，即稳定的两相流，整体和过冷沸腾不稳定流和过冷沸腾以及单相稳定流。 - The axial dispersion in chromatography models was discussed with vector method and the effect of diffusion on the bulk flow flux with its partial quantity form was pointed too.
用矢量方法讨论了色谱模型中的轴向扩散项，指出轴向扩散项是扩散通量以分量的形式在主体流动通量上的页献。 - Carbon steel charge pipe is accelerated oxidative exfoliation and grinding material abrasion under large ferroalloys furnace charging system s high temperature and bulk mine flow. Thick-walled stainless steel charge pipe is adopted to design new charging system which can operate smoothly for a long time.
针对大型铁合金电炉加料系统在高温环境和庞大矿物流量的工况下，碳钢料管加速氧化剥落和磨料磨损，采用厚壁不锈钢料管，设计了能够长期无故障运行的新加料系统。 - Appling planar critical angle, repose angle, size distribution, bulk density, friability, flow rate and yield percent to evaluate the quality of pellets, the pellets formulation was optimized by means of orthogonal design.
采用正交实验，以平面临界角、休止角、粒度分布、堆密度和脆碎度为质量评价指标，优化了微丸制备工艺，制得了各项指标均较好的微丸。 - Study on Concentration Profile Measurement Method for Bulk Solid Material Flow in Pipeline
封闭管道内散装固体物料流截面相浓度测量方法研究 - Thereinto, QoS metric is very important to many Internet application and protocols ( especially the application refered to bulk data transmission and multimedia flow limited by delay).
其中，QoS的测量对于许多Internet应用和协议，特别是涉及大量数据传输和具有时延限制媒体流的应用至关重要。 - A dynamic model for analyzing the dynamic characteristics of 3D large gap annular flow was developed based on Hirs 'bulk flow theory and Moody's fraction factor equation, and the effects of wall fraction was introduced.
建立了大间隙环流的三维动力学模型。该模型采用了Hirs整体流动理论和Moody壁面摩擦系数方程，考虑了壁面摩擦的影响，更为合理。 - The flow velocity got by traditional molecular dynamics method is the average value of bulk flow velocity and the molecules 'thermal motion over time. This method only can apply in the case of high speed flow problems.
传统的分子动力学方法是把流速与，分子热运动速度之和在一个长时间段上取平均值，这种方法只在流速相当大的情况下适用。 - The particle flow pattern tends to bulk flow in silo with the outlet size increasing.
随着料仓出口尺寸的增大，料仓内的颗粒流形趋于整体流。 - For low speed flow problems, because of the highly nonlinear coupling of the low bulk flow velocity and the high velocity of molecules 'thermal motion, and usually over-estimate the true flow velocity in such cases and lose its authenticity.
对于低速流动问题，由于较低的流动速度和较高的分子热运动速度的非线性耦合，流体的流速被大大地高估，失去其真实性。